Surveying·MCQ explained

Contour interval on a map sheet denotes:

Try it first: pick an option, then read the explanation.

Correct answer: B. Vertical distance between two successive contour lines

Detailed Explanation: Definition of Contour Interval

The contour interval (CI) is one of the most fundamental parameters of a contour map. It is chosen before surveying begins and remains constant throughout the entire map.

Precise definition:
The contour interval is the constant vertical elevation difference between any two consecutive contour lines on the map. For example, if a map has contours at 100 m, 105 m, 110 m, 115 m … the contour interval is 5 m. Every adjacent pair of contours on that map is separated by exactly 5 m vertically.

Why the Other Options Are Wrong

OptionWhat it actually describesWhy it is not CI
A — Vertical distance above datumThis describes the reduced level (RL) or elevation of a single contour lineCI is a difference between two contours, not the absolute height of one contour above datum
C — Slope distance between two contoursSlope distance is the actual ground distance measured along the inclined surface between the two contour pointsCI is purely a vertical measurement; slope distance includes both vertical and horizontal components
D — Horizontal distance between two contoursThis describes the horizontal equivalent (HE) — a different, variable quantityHE changes with slope steepness; CI is fixed and constant for the whole map

Contour Interval vs. Horizontal Equivalent

TermDefinitionVariable or fixed?
Contour Interval (CI)Vertical elevation difference between consecutive contoursFixed — same everywhere on the map
Horizontal Equivalent (HE)Horizontal map distance between consecutive contoursVariable — depends on local slope steepness

Key Concepts for Students

  • CI is vertical, HE is horizontal — never confuse them: This pair is tested repeatedly. CI is fixed by the surveyor before fieldwork; HE is a result of the terrain and varies from place to place on the same map.
  • Factors governing CI selection: Scale of map (larger scale → smaller CI), purpose (engineering design → small CI, reconnaissance → large CI), terrain relief (flat terrain → small CI to capture subtle variation, hilly → larger CI acceptable), and time/cost constraints.
  • CI is not slope distance: Slope distance runs along the inclined surface. CI is strictly the vertical component. For a vertical cliff, the slope distance equals CI (no horizontal component), but for any other angle the slope distance is longer than CI.