The representation of general topography of a very flat terrain is possible only by:
Try it first: pick an option, then read the explanation.
Correct answer: D. Giving spot levels to salient features at close interval
Detailed Explanation: Representing Flat Terrain on a Map
Very flat terrain presents a unique challenge in topographic mapping. Because elevation changes are so small across a large area, conventional contour lines become impractical — they would either be absent (if the CI exceeds the total relief) or so widely spaced as to be meaningless. A different approach is needed.
Why spot levels at close intervals on salient features is the answer:On very flat ground (e.g., alluvial plains, tidal flats, paddy fields), the total relief may be less than 1–2 m across hundreds of metres. If a CI of even 0.5 m is used, contours will be hundreds of metres apart and convey almost no useful information about the local surface variations. Instead, the standard practice is to:
• Identify salient features — slight undulations, low embankments, drainage channels, field boundaries, flood marks
• Record spot levels (point elevations) at these features at close intervals
• These spot elevations, plotted on the map, give the engineer a detailed picture of the subtle micro-relief that contour lines cannot capture
Why the Other Options Are Wrong
| Option | Why it fails for flat terrain |
|---|---|
| A — Large contour interval | A large CI on flat terrain means contours may be kilometres apart or absent entirely. No useful topographic information is conveyed. |
| B — Small contour interval | A small CI is better than large but still problematic on extremely flat ground — even 0.1 m CI contours may be too widely spaced to show meaningful variation, and locating them precisely in the field is very difficult. |
| C — Spot levels at large interval | Widely-spaced spot levels miss the subtle local variations that matter on flat ground. The key advantage of spot levels is only realised when taken at close intervals at the right locations. |
Key Concepts for Students
- Flat terrain → spot levels, not contours: This is the standard textbook guidance. Contour maps are effective for undulating or hilly terrain. On very flat ground, spot elevations at key points (benchmarks, road crossings, low points, drainage features) give a far clearer picture of the terrain than widely-spaced contours.
- Salient features on flat terrain: Even on apparently flat plains there are critical elevation points — the crown of a road, the lip of a drain, the top of a low bund, the floor of a field. Spot levels at these features, however close together, capture the engineering-relevant micro-relief.
- Flood-prone and irrigation design contexts: This principle is especially important in flat floodplain areas. Small elevation differences of 0.1–0.3 m determine drainage direction and flood extent. Only closely-spaced spot levels can capture this adequately for design purposes.