For measurement of vertical angles through theodolite, the instrument should be levelled with reference to the _____ bubble and the _____ clamp that is used to rotate the telescope in the vertical plane.
Try it first: pick an option, then read the explanation.
Detailed Explanation: Bubble and Clamp Used for Vertical Angle Measurement
This fill-in-the-blank question pairs two distinct concepts already introduced in this set: the altitude bubble (Q5) and the specific clamp that controls the telescope's vertical rotation, completing the practical picture of how a vertical angle is actually measured in the field.
Why "altitude" and "vertical circle" are the correct terms:As established in Q5, the altitude bubble mounted on the index frame is the levelling reference used immediately before reading a vertical angle — it ensures the vertical circle's vernier zero is truly horizontal at that instant. Separately, the telescope is physically rotated up and down (tilted) in the vertical plane using the vertical circle clamp (also called the clamping/tangent screw of the vertical circle), which locks the telescope at the desired tilt once sighted on the target, allowing a steady, vibration-free reading.
Why the Other Options Are Wrong
A — foot-screw; lower plate: Foot-screws are used for the initial general levelling of the entire instrument (centring the main plate bubble), not specifically for vertical angle index error. The lower plate clamp controls horizontal rotation, not vertical tilt.
B — altitude; upper plate: While "altitude" is correct, the upper plate clamp controls horizontal angle measurement (rotating the upper plate relative to the lower plate), not the vertical tilt of the telescope.
C — spindle; vertical plate: "Spindle" refers to the vertical rotation axes of the instrument body (inner/outer spindle for horizontal motion), and there is no standard component called the "vertical plate" on a theodolite — both terms are incorrect in this context.
Key Concepts for Students
- Match each clamp to its plane of motion: Lower/upper plate clamps → horizontal rotation (azimuth); vertical circle clamp → vertical rotation (altitude/depression). Keeping this pairing straight avoids confusing horizontal and vertical angle procedures.
- Sequence for a vertical angle reading: (1) Sight the target and lock the vertical circle clamp; (2) centre the altitude bubble using the clip screw; (3) read the vertical circle vernier. Skipping step 2 reintroduces index error.
- Tangent screw fine adjustment: After the vertical circle clamp is engaged, a small tangent screw allows fine adjustment of the telescope's tilt to sight the target precisely, without needing to loosen and re-tighten the main clamp.