Engineering Materials·MCQ explained

The thickness of the lintel is 80 mm and span of the lintel is 10 m. What will be taken as bearing of the lintel?

Try it first: pick an option, then read the explanation.

Correct answer: C. 100 mm

Understanding Lintel Bearing

To answer this question, we must first understand what "bearing" means in the context of a lintel.

What is Lintel Bearing?

Bearing is the length of the lintel that rests on the support (the wall) at each end. This bearing area is crucial because it's responsible for transferring the entire load collected by the lintel safely to the masonry wall below. If the bearing is insufficient, the stress on the supporting wall could be too high, leading to crushing or failure.

Guidelines for Lintel Construction (IS 456:2000)

The design and construction of lintels are governed by building codes to ensure safety and stability. The Bureau of Indian Standards code IS 456:2000 provides key principles for lintel design.

The Minimum Bearing Rule

One of the most important guidelines states that a lintel should have a minimum bearing length of 10 cm (100 mm) on each side. This is a standard minimum requirement to ensure adequate load transfer and prevent localized stress failure in the supporting wall.

Why are the thickness and span values given?

The question provides the lintel's thickness (80 mm) and span (10 m) to test your understanding. While these values are critical for designing the lintel's reinforcement and checking for deflection, they do not determine the minimum bearing length. The minimum bearing is a fixed value prescribed by the building code to ensure safety, regardless of the lintel's own dimensions.

Why 100 mm is the Correct Answer

Based on the standard building code provision:

  • The question asks what bearing will be taken for the lintel.
  • The standard minimum bearing required is 100 mm.
  • Therefore, regardless of the other dimensions given, the minimum value that must be provided for the bearing is 100 mm.

The options 80 mm and 90 mm are incorrect because they are less than the required minimum. While 110 mm is a safe bearing, the question is asking what value will be taken, and the standard minimum is the baseline for this determination.