Surveying·MCQ explained

The tangent length for a circular curve of radius R, if Δ is the deflection angle, is given by:

Try it first: pick an option, then read the explanation.

Correct answer: A. R tan(Δ/2)

Detailed Explanation: The Standard Tangent Length Formula

This question isolates the standalone tangent length formula already applied numerically in Q21 — confirming the exact, standard form used throughout circular curve design and setting-out calculations.

Why T = R tan(Δ/2) is correct:
The tangent length is the distance from the point of intersection (PI/apex) to either the point of curvature (PC) or the point of tangency (PT) — both distances are equal by the symmetry of a simple circular curve. Using the right-triangle relationship formed by the radius (perpendicular to the tangent at PC/PT), the tangent line, and the line from the centre to the PI, the standard formula is:

T = R tan(Δ/2)

Why the Other Options Are Wrong

B — R tan(Δ): Uses the full deflection angle instead of half — this omits the essential halving step found in virtually every circular curve element formula (tangent length, long chord, versed sine, apex distance all use Δ/2).

C — ½R tan(Δ): While this introduces a factor of ½, it applies it to the wrong location (as a coefficient of R rather than inside the tangent function as Δ/2) — mathematically distinct from, and generally not equal to, the correct R tan(Δ/2).

D — ½R tan(Δ/2): Correctly halves the angle inside the tangent function but then incorrectly also halves the overall radius coefficient — an extra, unwarranted factor of ½ that does not belong in the standard formula.

Quick Cross-Reference: Curve Element Formulas

ElementFormulaTrig function
Tangent length (T)R tan(Δ/2)Tangent
Long chord (L)2R sin(Δ/2)Sine
Versed sine (M)R[1−cos(Δ/2)]Cosine
Apex/external distance (E)R[sec(Δ/2)−1]Secant
Curve length (l)πRΔ/180°None (direct proportion)

Key Concepts for Students

  • Memorise this table as a complete set: All five formulas use Δ/2 (except curve length, which uses the full Δ) — recognising this consistent pattern across tangent length, long chord, versed sine, and apex distance helps avoid the half-angle omission error seen in option B.
  • Tangent length is used to locate the PC and PT on the ground: Before any curve points can be set out, the surveyor first measures the tangent length T back from the PI along each straight to mark the PC and PT — making this one of the very first calculations performed in any curve-setting exercise.
  • Cross-check with Q21's numerical worked example: This standalone formula question and Q21's applied calculation (degree of curve → radius → tangent length) together provide both the conceptual formula and a complete worked numerical example for full mastery of this curve element.